⎯ 154 ⎯
6 F 2 S 0 7 1 5
3.3 Zoom In and Out Locus Diagram
This section describes how to zoom in and out the locus diagram.
《Note for Operation》
● The following operations are available.
・Zoom In Designated Range You can zoom in the designated range.
・Zoom In, Out You can zoom in and out the locus diagram.
・Moving the center of You can move the center of the coordinate axis.
the coordinate axis
・Move to Center You can move the center of the coordinate axis to
the center of the screen.
・Normal You can return the locus diagram to the status in
which the locus diagram is displayed for the first
time.
《Operating Procedure》
① To zoom in the designated range, click [View], and then click [Zoom In Designated
Range].
3-6
To Next Page
Loading...