⎯ 134 ⎯
6 F 2 S 0 7 1 5
■Displaying Impedance Value
This part describes how to display the impedance values for 1 cycle before the active cursor
position.
《Note for Operation》
● Select phase order before operating.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Phase Order)
● You can select the primary values or the secondary values for the impedance values.
You can select the leading display or delay display for the phase differences.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Analysis] menu, click [Impedance].
③ The impedance values of the current phase order setting are displayed.
･ The impedance values for 1 cycle before the cursor position are calculated.
･ The phase differences between the vectors of the real number and the vectors of the imaginary number
are displayed.
･ You can update the values by moving the cursor.
･ [--------] is displayed where it can not be analyzed.
2-22
To Next Page
Loading...