Toshiba RSM 100 - Selecting Reference Phase

⎯ 114 ⎯
6 F 2 S 0 7 1 5
2.1 Setting Parameters for
Measurement and Analysis
This section describes how to set the parameters required for calculating the measurement
and analysis values.
■Selecting Unit of Displayed Time
■Selecting Reference Phase
■Selecting Phase Order
■Selecting Options
■Selecting Unit of Displayed Time
This part describes how to select the unit of the time displayed while the measurement and
analysis operations.
《Note for Operation》
● You can previously select a unit for the time displayed when a waveform data is
displayed. (→■Selecting Options)
《Operating Procedure》
① On the [Set] menu, point to [Unit of Time], and then click the unit in which you want to
display the time.
② The time is displayed in the selected unit.
2-2