Toshiba RSM 100 - Displaying Vector Diagram

⎯ 135 ⎯
6 F 2 S 0 7 1 5
2.4 Displaying Vector Diagram
This section describes how to display the vector diagram of the waveform.
■Displaying Vector Diagram
■Setting Parameters
■Displaying Vector Diagram
Consecutivel
y
■Displaying Vector Diagram
This part describes how to display the vector diagram of the three-phase or symmetrical
components for 1 cycle before the active cursor position.
《Note for Operation》
● Select phase order before operating.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Phase Order)
● You can select the primary values or the secondary values for the RMS values.
You can select the leading display or delay display for the phase differences.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Analysis] menu, click [Vector Diagram].
2-23