⎯ 116 ⎯
6 F 2 S 0 7 1 5
③ The phase differences and the RMS values at the active cursor are displayed.
The reference phase is marked with [*].
④ On the [Set] menu, Click [Reference Phase].
⑤ Click the down arrow button that appears just to the right of [Channel] drop-down list
box and click the channel number of the AC element that is the reference phase to
display the measurement value.
⑥ Click the down arrow button that appears just to the right of [Phase Order] drop-down
list box and click the phase order that is the reference phase to display the analysis
values.
⑦ Click【OK】button.
･ The reference phase is selected.
･ The new selected reference phase is marked with [*].
CAUTION
The [Reference Phase Setting] dialog box is displayed
only when a menu related to phase difference including
[Phase Difference] on the [Measurement] menu and
[Reference Phase] on the [Analysis] menu is selected.
2-4
To Next Page
Loading...