Toshiba RSM 100 - Binary output test

⎯ 68 ⎯
6 F 2 S 0 7 1 5
Binary output test
It is possible to forcibly operate all binary output relays for checking connections with the external
devices (only G1IF4). Forced operation can be performed on one or more binary outputs at a time
for each module.
Click the [Binary output] tab to open the screen.
If forcibly operating binary output, set the “New” column to “Enable” on the line of a binary
output (module and output number). And click the [Test on] button. If set the binary output to
“Disable” and click the [Test on] button, the binary output is reset.
Be sure to reset to “Disable” when the relay resumes service. If not, the relay may not operate
correctly.