Software Installation
Strata CIX Database Programming
2-14 Strata CIX PC Attendant Console Installation 06/09
4. Click on OK.
5. The screen will change to the Full IP Station Assingment (command 260).
6. Enter the first four digits of the MIPU (xIPU) card equipment number (cabinet/slot), do not
enter a port number.
7. In the 01 Type field pull down list, select ATT.
8. Toshiba recommends entering COS 10 for the following:
• COS DAY1=10
• COS DAY2=10
• COS Night=10
9. For Call Progress Tones assign Dial Tone. This assigns Dial Tone as the tone heard after LCR
access codes are dialed (required).
10. You must create this as a new port. The ATT parameter cannot be changed later. If the DN
already exists it must be deleted and then added as a new ATT port.
DKT Data Assignments
1. Select Station > Station Assignments, click on the Prime DN for this particular Attendant
Console in the list on the right side of the screen.
1. Enter data for the FBs listed below:
p 01 – Station Type select “Attendant” from the pull down list (required).
p 02 – Select the Key Strip Pattern for the Attendant Console (required).
p 05 – Assign Tone First signaling (required).
To Next Page
Loading...
