Toshiba Super MMY-MAP0801HT8 - Propeller Fan Motor; Cabinet; Reolacing Method of Parts

249
Discharge cabinet
Screws (4 corners)
5
Suction cabinet
(Front and rear)
3
Lower cabinet
(Front and rear)
6) Side board
(Right and left)
5) Suction cabinet
(Front and rear)
3) Lower cabinet
(Front and rear)
6) Side board
(Right and left)
4) Service panel
Suction cabinet
* Hooking claw
2 × 3 positions each at
longitudinal direction
Screws (4 corners)
2)
2)
( )
16. REOLACING METHOD OF PARTS
No.
1
Part to be
exchanged
Cabinet
Work procedure
REQUIREMENT
Put on gloves during working; otherwise an
injury may be caused by parts, etc.
<Disassembling>
1) Stop operation of the air conditioner, and
then turn off the switch of the breaker.
2) Take off screws of the discharge cabinet.
(M5 × 10, 4 pcs.)
3) Take off screws (Front/rear at lower side) of
the cabinet. (M5 × 10, 7 pcs. each)
4) Take off screws of the service panel.
(M5 × 10, 3 pcs.)
5) Take off screws (Front/rear sides) of the
suction cabinet.
(M5 × 10, 4 pcs. each)
(M4 × 10, 2 pcs. each)
6) Take off screws (Right/left sides) of the side
panel. (M5 × 10, 4 pcs. each)
Remarks
2 Propeller fan
motor
REQUIREMENT
Put on gloves during working; otherwise an
injury may be caused by parts, etc.
<Disassembling>
1) Stop operation of the air conditioner, and
then turn off the switch of the breaker.
2) Take off screws of the discharge cabinet.
(M5 × 16, 4 pcs.)
<Reassembly>
Reassemble the cabinet in the reverse proce-
dure ( 6) → 1) ) of the above “Disassembling”.
However be sure to the following points when
assembling the discharge cabinet.
w Cautions when assembling the discharge
cabinet
Fit the claws ∗ (6 positions) inside of the
discharge cabinet surely. (If the claws come
off, a vibrating noise may generate.)