Using handy features
■ Using auto setting (Only for analog input from computer)
This function sets up the projector to the optimum state such as
sampling phase, frequency, screen position, and clamp for each
type of the input signal by using simple operations.
Press the remote control’s AUTO SET button.
For computer input, the icon will appear during processing.
Notes
• The image may not be projected or auto adjustment/setting may
not be performed correctly for input signals other than those
supported by the projector
.
■ Correcting the keystone distortion
When the projector placement angle against the
screen is changed while projecting the image,
the picture will undergo keystone (trapezoidal)
distortion.
This projector is capable of correcting this key-
stone distortion
.
Press the KEYSTONE or button.
Control panel
Before correction
After correction
Remote
Control
To Next Page
Loading...
Need help?
General
