34
■ Displaying Information (Status display)
This displays information about the input signal,lamp use time,etc.
“Yes”: displayed, “No”: not displayed
Item Description
Computer Y/PB/PR Video S-video
Input Input source name Yes Yes Yes Yes
Resolution Resolution (in dots) Yes No No No
Video mode Color method of video signal No Yes Yes Yes
Picture mode A group of Pre-set display mode Yes Yes Yes Yes
Lamp time Time of lamp use
[Note 3]
Yes Yes Yes Yes
Version Firmware version
[Note 4]
Yes Yes Yes Yes
Notes
1: The mode of supported RGB signals
is shown.
2: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
3: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as
a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult
with a store about getting a TLPLV6 replacement lamp (sold separately) prepared.
4: [Version] shows the version of the projector’s internal control program. This version is referred
to for customer service, etc.
Using the menus (Continued)
To Next Page
Loading...
