Toshiba TECRA M11 Series - Fin Cover

4.5 Fin cover 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-19
4.5 Fin cover
NOTE: When repairing the PC, turn up the plastic film and clean the cooling fin with a
vacuum cleaner or other cleaning tool.
Do not use cotton sticks and tweezers to remove dusts. It may cause the cooling
module problem or dusts stuffed.
Removing the Fin cover
To remove the fin cover, follow the steps below and refer to Figure 4-7.
1. Using a thin-tipped tool, push on the hole in the edge of the Fin cover and remove the
fin cover while sliding it in the direction in the figure below.
Figure 4-7 Removing the fin cover
Fin cover
Hook
Hole
Plastic film