Toshiba TECRA M11 Series - 4.23 LCD Unit Replacement Procedures

4.23 LCD unit 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-91
4.23 LCD unit
Removing the LCD unit
To remove the LCD unit, follow the steps below and refer to Figure 4-51 to 4-57.
1. Peel off the insulators (SQUARE INSULATOR and HNS 3G INSULATOR).
NOTE: Do not reuse the removed SQUARE INSULATOR. Be sure to use a new SQUARE
INSULATOR.
2. Release the 3G antenna cables from the guides and take them out from the hole of
the cover assembly.
Figure 4-51 Removing the LCD unit (1)
SQUARE INSULATOR
HNS 3G
INSULATOR
3G antenna cable
Guide
Guide
Hole