4.12 Cover assembly and Base assembly 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-41
4 Replacement Procedures
4.12 Cover assembly and Base assembly
Removing the Cover assembly and Base assembly
To remove the cover assembly and base assembly, follow the steps below and refer to Figure
4-22 to 4-26.
1. Close the display and turn over the computer.
2. Disconnect the 3G antenna cables and 3G power harness from the connectors on
the jack/3G/Express board.
Figure 4-22 Removing the cover assembly and base assembly (1)
3G power harness
3G antenna cable (red)
3G antenna cable (blue)
To Next Page
Loading...
