4.17 Jack/3G/Express board/Microphone/3G card 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-59
4.17 Jack/3G/Express board/Microphone/3G card
Removing the Jack/3G/Express board/Microphone/3G card
To remove the jack/3G/Express board/Microphone/3G card, follow the steps below and refer
to Figure 4-33 to 4-35.
1. Disconnect the jack/3G/Express board FPC from the connector CN9530 on the
system board.
2. Disconnect the speaker harness from the connector CN6150 on the jack/3G/Express
board.
3. Remove the following screw securing the jack/3G/Express board.
• M2.5×6C Tapping screw ×1
Figure 4-33 Removing the jack/3G/Express board (1)
CN6150
Speaker harness
M2.5x6C Tapping
Jack/3G/Express board FPC
CN9530
To Next Page
Loading...
