4.11 Wireless LAN card 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-39
4.11 Wireless LAN card
Removing the Wireless LAN card
To remove the wireless LAN card, follow the steps below and refer to Figure 4-21.
1. Disconnect the wireless LAN antenna cables from the wireless LAN card (white
cable from “A” or “1”, black cable from “B” or “2” and gray cable from “C” or “3”)
using an antenna coaxial cable disconnector.
2. Remove the following screws securing the wireless LAN card.
• M2.0×3C BIND screw ×2
3. Disconnect the wireless LAN card from the connector on the system board.
Figure 4-21 Removing the wireless LAN card
M2.0x3C BIND
Wireless LAN card
Wireless LAN antenna cable (White)
Wireless LAN antenna cable (black)
Wireless LAN antenna cable (gray)
To Next Page
Loading...
