4 Replacement Procedures 4.10 SW board
4-38 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the SW board
To install the SW board, follow the steps below and refer to Figure 4-20.
1. Slide the SW board into the guide to set it.
2. Turn up the insulator (LCD CONN INSULATOR) and connect the SW board FFC
to the connector CN9500 on the system board.
NOTE: Arrange the SW board FFC under the guide.
SW board FFC
Guide
To Next Page
Loading...
