4.7 HDD 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-27
Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-11 to 4-13.
1. Set the HDD to the HDD Holder and secure them with the following screws.
• M3.0×4C FLAT HEAD screw ×4
NOTE: When replacing the HDD holder with a new one, stick the HDD cushion to the
HDD holder in place.
2. Connect the HDD assembly to the connector on the system board. Lay the HDD
assembly down into the slot.
3. Set the HDD cover and secure it with the following screw.
• M2.5×5B FLAT HEAD screw ×1
HDD cushion
HDD holder
To Next Page
Loading...
