4 Replacement Procedures 4.14 RTC battery
4-54 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the RTC battery
To install the RTC battery, follow the steps below and refer to Figure 4-30.
1. Open the insulator (RTC BATT INSULATOR) and set the RTC battery in place.
2. Close the insulator (RTC BATT INSULATOR) to fix the RTC battery.
3. Connect the RTC battery harness to the connector CN9300 on the system board.
4. Stick the acetate tape in place.
To Next Page
Loading...
