4.18 RGB/USB board 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-65
3. Take out the DC-IN harness from the slot of the base assembly.
4. Take out the RGB/USB board from the slot of the base assembly. (USB harness is
still connected to the back of the RGB/USB board.)
5. Disconnect the USB harness from the connector CN9610 on the RGB/USB board.
Figure 4-37 Removing the RGB/USB board (2)
USB harness
RGB/USB board
CN9610 (back of the RGB/USB board)
DC-IN harness
To Next Page
Loading...
