4.19 System board 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-71
4. Turn up the insulator (HNS HOLD RJ INSULATOR) and connect the RJ45 harness
to the connector CN4050 on the system board.
NOTE: When replacing a system board with a new one, stick the HNS HOLD RJ
INSULATOR in place.
5. Connect the RGB harness to the connector CN9511 on the system board.
6. Turn over the system board.
To Next Page
Loading...
