4.20 CPU/Fin/DC fan 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-79
10. Set the fin (with the DC fan) in place and secure it with the following screws.
• M2.0×4B BIND screw ×8
NOTE: When securing the fin, be sure to secure the screws in the order of the number
marked on the fin.
In models without a VGA, make sure that the gum sheet VGA is set on the system
board in place.
11. Connect the fan harness to the connector CN3380 on the system board.
To Next Page
Loading...
