4.23 LCD unit 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-95
8. Peel off the acetate tape.
9. Release the harnesses.
10. Turn the brake hinge 90 degrees.
11. Remove the following screws and stand the LCD unit.
Be careful that the LCD harness is connected to the connector on the back of the
LCD unit.
• M2.5×5B FLAT HEAD screw ×4
Figure 4-55 Removing the LCD unit (4)
Acetate tape
M2.5x5B FLAT HEAD
M2.5x5B FLAT HEAD
M2.5x5B FLAT HEAD
LCD unit
Brake hinge R
To Next Page
Loading...
