8-10 User’s Manual
Optional Devices
Installing memory module (2nd memory)
Follow the steps below to install a memory module.
1. Save data, shutdown Windows and turn the power off.
2. Remove the AC adapter cable and other cables from the computer.
3. Close the display panel and turn the computer over. Remove the
battery pack.
4. Loosen a screw on the cover of the memory module slot.
Figure 8-11 Removing the memory module cover
5. Insert the memory module obliquely against the connector of the
memory module slot. Gently push the memory module until it is secured
in place.
Figure 8-12 Installing a module
■ Align the grooves of the memory module with the locking tabs of the
connector and insert the module into the connector firmly. If you find it
difficult to install the memory module, try to adjust the tabs of the
connector with a pen tip or other tools. Make sure to hold the memory
module with your fingers on the side edges (sides with grooves).
To Next Page
Loading...
