User’s Manual 8-13
Optional Devices
8. Lift the HDD pack and remove it.
Figure 8-16 Removing the HDD pack
Installing the HDD pack
To install the hard disk drive, follow the steps below.
1. Place the HDD into the space for HDD. Slide the HDD to connect to the
connector.
2. Fold over the plastic tab so that it goes into the HDD space. Press the
HDD to ensure a firm connection.
Figure 8-17 Installing the HDD pack
3. Seat the cover and press down until the latches click into place.
4. Secure the cover with a screw.
Additional battery pack
You can increase the portability of the computer with additional battery
packs. If you’re away from an AC power source and your battery runs low,
you can replace it with a freshly charged battery. Refer to Chapter 6, Power
and Power-Up Modes.
To Next Page
Loading...
