F-2 User’s Manual
Internal Modem Guide
Removing the internal modem
To remove the internal modem, follow the steps below.
1. Save your data and turn off the computer.
2. Disconnect the AC adaptor and any other peripheral device.
3. Turn the computer upside down and remove the battery pack.
4. Perform the step from 4 to 9 of installation the internal modem.
5. Remove two screws and remove the modem board.
6. Disconnect the modem cable.
7. Insert tabs on the front of the keyboard into corresponding notches on
the computer and seat the keyboard.
8. Two screws secure the keyboard.
9. Seat the keyboard brace and press to secure latches.
10. Install the battery pack.
Refer to the installation procedures for details.
A02-0604JP
To Next Page
Loading...
