User’s Manual 4-3
Operating Basics
1. To remove the AccuPoint cap, firmly pinch the cap and pull it
straight up.
Figure 4-2 Removing the AccuPoint cap
2. Position a new cap on the peg and press it into place.
Using the USB floppy disk drive
A 3 1/2" floppy disk drive connects to the computer’s USB port. It
accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2, The Grand Tour, for more information.
Connecting 3 1/2" floppy disk drive
To connect the drive, plug the floppy disk drive connector into a USB port.
Refer to Figure 4-3.
Figure 4-3 Connecting the USB floppy disk drive
The peg is square, so be careful to align the cap’s square hole with the
peg.
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection; doing so can damage the
connecting pins.
If you connect the floppy disk drive after turning on the computer, it will
take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
To Next Page
Loading...
