8-12 User’s Manual
Optional Devices
6. Reinstall the cover of the memory module slot. Fasten the screw you
loosened in Step 4.
7. Reinstall the battery pack.
Hard disk drive pack
An extra HDD expands the flexibility of your system and lets you carry your
data without carrying the computer.
Removing the HDD pack
To remove the HDD pack, follow the steps below and refer to figures 8-15
and 8-16.
1. Set the computer to boot mode and turn off the power.
2. Disconnect the AC adaptor and all external cables connected to the
computer.
3. Remove the main battery and optional secondary battery when it is
used.
4. Turn the computer upside down and remove one screw securing the
HDD cover.
5. A small row of ridges mark latches securing the cover. Press on these
ridges until you hear a click.
6. Press on the arrows and lift the cover up and out to remove it.
Figure 8-15 Removing the HDD pack cover
7. Raise the HDD’s plastic tab, pinch it and slide the HDD pack to
disconnect from the connector.
After installing a memory module, turn the power of the computer on to see
a total memory size. The system will calculate the total memory size.
Use a point size 0 Phillips screwdriver.
Be sure to slide the HDD pack first and confirm that the HDD pack has
disconnected.
To Next Page
Loading...
