User’s Manual 1-7
Introduction
TOSHIBA Dual Pointing Device
Ports
Slots
Built-in Touch Pad A Touch Pad and control buttons in the palm rest
enable control of the on-screen pointer and
scrolling of windows.
Built-in AccuPoint This pointer control stick, located in the center of
the keyboard, provides convenient control of the
cursor.
Parallel Parallel printer or other parallel device (ECP
compatible).
External monitor 15-pin, analog VGA port supports VESA DDC2B
compatible functions.
Universal Serial Bus
(USB 2.0)
The computer has two Universal Serial Bus ports
that comply with the USB 2.0 standard, which
enables data transfer speeds 40 times faster
than the USB 1.1 standard. (The ports also
support USB 1.1.)
Docking interface This port enables connection of an optional
Advanced Port Replicator III described in the
Options section.
i.LINK™ (IEEE1394) This port enables high-speed data transfer
directly from external devices such as digital
video cameras. Some models are equipped with
a i.LINK port.
Infrared The serial infrared port is compatible with
Infrared Data Association (IrDA 1.1) standards. It
enables cableless 4 Mbps, 1.152 Mbps, 115.2
kbps, 57.6 kbps, 38.4 kbps, 19.2 kbps or 9.6
kbps data transfer with IrDA 1.1 compatible
external devices.
PC card The PC card slot accommodates two 5 mm Type
II cards or one Type III card.
SD card This slot lets you easily transfer data from
devices, such as digital cameras and Personal
Digital Assistants, that use SD card flash-
memory.
You can use memory module in this slot.
To Next Page
Loading...
