EO1-13021
5. INSTALLATION PROCEDURE
5.1 Connecting the Power Cord and Interface Cable
5-1
5. INSTALLATION PROCEDURE
WARNING!
1. Since the power cord and the interface cable are not provided with this unit, please locally
purchase ones which meet the specifications. For detail specifications, please contact your
nearest authorized TOSHIBA TEC representative.
2. Before connecting the power cord and cables to the printer, turn the power of the POS
terminal and printer OFF.
3. Do not pull the power cord hard. Doing this may damage the power cord, causing fire, electric
shock, or broken wire.
4. When it thunders, unplug the power cord. Lightning stroke may cause fire or electric shock.
5. Keep the power cord away from a heater. The cover of the power cord may be melted,
causing fire or electric shock.
6. Do not connect the power cord to the AC outlet provided on the POS terminal such as ST-
5600, ST-5500, etc.
CAUTION!
1. When separating the AC adapter, please contact your authorized TOSHIBA TEC
representative.
2. The built-in AC adapter is exclusively for this printer. Do not use it for any other machines.
3. The AC adapter can be used indoors only. Never use it outdoors.
4. Be sure to unplug the printer when it is not used for a long time.
5. Do not share the power source with other electric appliances which generate noise.
To Next Page
Loading...
Need help?
General