6F8C0878 39
3.2 Network Parameter Setting
3
(9) Confirm the current setting of EN7 module.
First, connect the Engineering Tool 2 to the serial communication port of the EN7
module (TOOL) and take out the setting. Set the transmission parameter from [Tool
(T)][comm param (P)] of the product tree. In this case, confirm the setting using the
serial communication port.
Com. Method: RS-232C, Port: COM1 (specify COM1 (in this case) as the port to
use),Timeout (s): 5.
Ethernet, Timeout (s): 3, Local Station Settings: Single (free mode), IP Address:
172.16.64.1. Then, press [OK] button.
To Next Page
Loading...
