6F8C0878 51
4.2 Ethernet Cable Connection
4
4.2.3 100BASE-TX/10BASE-T (EN751, EN751A, EN761, FN711)
Connect the category 5 twisted pair cable to an Ethernet connector (EN-A or EN-B).
(Exercise care about the direction of the connector tab.) After inserting the cable into the
connector, check that it is locked.
Figure 4-6 Connecting Category 5 Twisted Pair Cable
Caution
To prevent control and monitor congestion due to a high transmission load, connect the FN711
not to an information LAN but to a control LAN which is designed safe against transmission
loads.
EN7 module
Ethernet connector
To Next Page
Loading...
