Toshiba V Series - Default Gateway IP Address (Router IP Address); Setting

6F8C0878 45
3.2 Network Parameter Setting
3
3.2.9 Default gateway IP address (Router IP address) setting
(1) In using the default gateway (router), Set a default gateway IP address (router IP
address).There is only one default gateway IP address that can be set.
The default gateway can be used only if IPF ON and IP address type [Setting from
Tool] are set using the operation mode switches.
The default gateway function is valid for EN711, EN731, EN751, and EN751A only
(invalid for EN721, EN741, EN761 and FN711).
(2) Register a default gateway IP address having the same value as the network address
part (including the subnet) of the IP address for the EN7 module to be registered. (In
the present case, 192.168.0.**)
An example of setting is shown below.
(In the present case, 192.168.0.10 (subnet mask: 255.255.255.0))
Figure 3-7 System Configuration of a Default Gateway IP Address Setting Example
Default gateway
(router)
EN711
Personal computer,
for example
192.168.0.20
192.168.0.10
xx.yy.zz.vv