To Next Page

To Previous Page

Unified Controller Vm series TC-net (TNB) Module Instruction Manual

vii

This manual describes the functions, methods of wiring and setting, and maintenance and

inspection of the TC-net 100 extended I/F module ("TNB" hereafter) for connecting the

information/control network TC-net 100 to the controller of Unified Controller Vm series.

To use this device correctly, read "Safety precautions" first.

After reading this manual, keep it in a safe place so that you can read it wherever necessary.

The manuals related to the TNB module are as follows.

 Unified Controller Vm series Controller typeS Instruction Manual (6F8C1652)

Describes the main unit connection, maintenance of the typeS controller.

 Unified Controller Vm series Controller typeS PLC CPU Function Manual (6F8C1645)

Describes the functions and basic use of the typeS PLC CPU.

 Unified Controller /Integrated Controller Command Manual (6F8C1226)

Describes the detailed specifications of the instruction words of the

program languages (LD, FBD, and SFC) supported by the Unified

Controller and Integrated Controller.

 Unified Controller /Integrated Controller Engineering Tool 4 Operation (6F8C1290)

Manual -Basic-

Describes how to create, debug, print, and save programs with using nV-

Tool.

 Unified Controller /Integrated Controller Engineering Tool 4 Operation (6F8C1291)

Manual -Setup-

Describes how to set up nV-Tool.

 Unified Controller Vm series TC-net 100 extended module TNB Instruction (6F8C1637)

Manual(This document)

Describes the TC-net 100 interface extended I/F module of Vm series

controller.

Introduction

Toshiba Vm Series User Manual

Other manuals for Toshiba Vm Series