TOSOT DC INVERTER U-MATCH AIR
25
accumulated operating time is 1400hr. Each time the latter digit increases 1, the accumulated operating
time increases 400hr. When it reaches 9, it means the accumulated operating time is 5000hr.
(4) Heavy pollution: the former digit in timer zone shows 3 while the latter one shows 0, which indicates the
accumulated operating time is 100hr. Each time the latter digit increases 1, the accumulated operating
time increases 100hr. When it reaches 9, it means the accumulated operating time is 1000hr.
The detailed pollution level and the corresponding time is as shown in Table 2-4-1 below:
Table 2-4-1 Pollution level and corresponding time
Accumulated
operating time
(hour)
Accumulated
operating time
(hour)
Accumulated
operating time
(hour)
If filter clean reminder function is turned on, the icon will be on.
(1) If cleaning time is not reached, no mater the setting is changed or not, the accumulated operating time
won’t be recalculated when pressing Enter/Cancel button.
(2) If cleaning time is reached, in unit on or off state, will blink every 0.5s for reminder. Press
Function button to switch to icon and press ▲ and ▼ button to adjust the level. Then press
Enter/Cancel button, so the accumulated operating time won’t be cleared (If the adjusted level is higher
than the present accumulated operating time, the icon won’t blink any more; if the adjusted level is lower
than the present accumulated operating time, the icon will go on blinking).
(3) The only way to cancel filter clean reminder function is to press Function button to switch to filter clean
reminder function. The icon will blink and press ▲ or ▼ button to adjust timer zone to display
“00”. In this case, the accumulated operating time will be cleared.
4.2 Low Temperature Drying Function
Under dry mode and when set temperature is 16
℃
(61
℉
), continuously press ▼ button for twice
and then the set temperature will be 12
℃
(54
℉
). In this case, the unit will enter low temperature drying
function.
When low temperature drying function is turned on, press ▲ button or Mode button to exit low
temperature drying function.
4.3 Lock Function
When unit is turned on normally or turned off, pressing ▲ and ▼ buttons at the same time for 5s will
turn on Lock function. LCD will display . Pressing ▲ and ▼ buttons at the same time for 5s to turn off
this function.
When Lock function is turned on, any other buttons won’t respond when pressing. The function can