TOSOT DC INVERTER U-MATCH AIR
30
4.9.12 Selecting Compensation of Temperature Sensor at Air Return
Under debugging state, press Mode button to adjust to “12” in temperature displaying zone. Timer
zone displays setting state and press ▲ or ▼ button to adjust. There are 16 selections:
(1) Compensate 0
℃
(32
℉
) (LCD displays 00)
(2) Compensate 1
℃
(34
℉
) (LCD displays 01)
(3) Compensate 2
℃
(36
℉
) (LCD displays 02)
(4) Compensate 3
℃
(37
℉
) (LCD displays 03)
(5) Compensate 4
℃
(39
℉
) (LCD displays 04)
(6) Compensate 5
℃
(41
℉
) (LCD displays 05)
(7) Compensate 6
℃
(43
℉
) (LCD displays 06)
(8) Compensate 7
℃
(45
℉
) (LCD displays 07)
(9) Compensate 8
℃
(46
℉
) (LCD displays 08)
(10) Compensate 9
℃
(48
℉
) (LCD displays 09)
(11) Compensate 10
℃
(50
℉
) (LCD displays 10)
(12) Compensate 11
℃
(52
℉
) (LCD displays 11)
(13) Compensate 12
℃
(54
℉
) (LCD displays 12)
(14) Compensate 13
℃
(55
℉
) (LCD displays 13)
(15) Compensate 14
℃
(57
℉
) (LCD displays 14)
(16) Compensate 15
℃
(59
℉
) (LCD displays 15)
NOTE:
Indoor ambient temperature compensation can be set through wired controller
E.g. If 02 is selected, it indicates the compensation temperature is 2
℃
(36
℉
). If the indoor ambient
temperature detected by the temperature sensor at air return is 29
℃
(84
℉
), the ambient temperature
after compensation is 29
℃
(84
℉
)-2
℃
(36
℉
)=27
℃
(48
℉
).
After finishing setting, press Enter/Cancel button to save and exit setting. After entering this
interface, the system will exit this menu if there is no operation on the button within 20s. Normal off state
interface will be displayed and present setting will not be saved.
To Next Page
Loading...
Need help?
General
