Toto EcoPower - User Manual

Other manuals for Toto EcoPower

Installation Manual2 pages

Questions and Answers

W
wsinghJul 27, 2025
Why is no water coming from the Toto EcoPower Control Unit flush valve?
- J
  Janet HuangJul 27, 2025
  If no water comes from the flush valve, several issues might be at fault: * The main valve in the water supply line or the control stop might be shut off. If so, open the main valve or the control stop. * The connector might not be connected; ensure the wire is connected. * The surface of the glass in front of the infrared sensor might be dirty; clean the glass surface. * There might be a reflective surface in front of the sensor; remove it. * The small holes in the solenoid diaphragm might be clogged; clean the small hole in the diaphragm and filter. * The hydropower generator might be clogged; service the hydropower generator. * If the glass is broken, or the infrared sensor or the solenoid is out of order, contact your distributor for a replacement.
J
Jeffrey GregoryAug 2, 2025
What to do if water does not stop flowing in Toto EcoPower?
- K
  Kathy ChaseAug 2, 2025
  If the water doesn't stop flowing, check these potential causes: * The small hole in the piston is clogged (not for TEU*UA(R)(X)). Clean the small hole in the piston. * The sealing area of the piston is dirty (not for TEU*UA(R)(X)). Clean the sealing area of the piston. * The sealing area of the solenoid diaphragm is dirty. Clean the sealing area of the diaphragm and filter. * The Piston U-packing might be damaged (not for TEU*UA(R)(X)). Inspect and replace it if necessary.
A
Amanda NortonAug 9, 2025
How to adjust the flow rate on a Toto EcoPower Control Unit if it's too high?
- T
  Tammy ParkerAug 9, 2025
  If the flow rate is too high, the control stop might not be adjusted properly. Adjust the control stop accordingly.
D
dianehurleyAug 15, 2025
How to fix low flow rate on Toto Control Unit?
- G
  garrett08Aug 15, 2025
  If the flow rate is too low, it could be due to these reasons: * The water supply pressure is too low (below the rated minimum pressure). Consult with a plumbing contractor. * The control stop is not open enough. Adjust the control stop properly.
K
Kevin RichardsonAug 20, 2025
How to increase the discharge quantity of a Toto EcoPower Control Unit?
- C
  cherylfloresAug 20, 2025
  If the discharge quantity is too small, the screw of the control stop or the screw of the piston valve are not adjusted properly. Adjust the discharge quantity by the screw of the control stop and the screw of the piston valve.