Toyopuc PC3 - Data Type <Type> Is Not Valid for Device Address <Address; Device Address <Address> Is Read Only; Array Size Is out of Range for Address <Address; Array Support Is Not Available for the Specified Address: <Address

Toyopuc PC3/PC2 Ethernet Driver
Verify the address is correct; if it is not, re-enter it in the client application.
Data Type <type> is not valid for device address <address>.
Error Type:
Warning
Possible Cause:
A tag address that has been specified dynamically has been assigned an invalid data type.
Solution:
Modify the requested data type in the client application.
Device address <address> is read only.
Error Type:
Warning
Possible Cause:
A tag address that has been specified dynamically has a requested access mode that is not compatible with
what the device supports for that address.
Solution:
Change the access mode in the client application.
Array size is out of range for address <address>.
Error Type:
Warning
Possible Cause:
A tag address that has been specified statically is requesting an array size that is too large for the address
type or block size of the driver.
Solution:
Re-enter the address in the client application to specify either a smaller value for the array or a different
starting point.
Array support is not available for the specified address: <address>.
Error Type:
Warning
Possible Cause:
A tag address that has been specified statically contains an array reference for an address type that doesn't
support arrays.
Solution:
Either re-enter the address in the client application to remove the array reference or correct the address
type.
www. kepware.com
32