Toyopuc PC3 - Module Configuration Appendix; Configuring the PC10 G-CPU for Ethernet Connections

To Next Page

To Previous Page

Toyopuc PC3/PC2 Ethernet Driver

Appendix: Configuring Modules

Configing the FL_ET-T-V2 Ethernet Module

Configuration Ladder for EN-I_F Ethernet Module

Configuring the PC10G CPU for Ethernet Connections

Configuring the PC10G-CPU for Ethernet Communications

Before the PC10G-CPU can be used for Ethernet communications, it must be configured using PCWin

version 10 or above. The following example first shows how to configure the built-in Ethernet port L2 and

then shows how to connect to the PC with PCWin to the PC10G-CPU using a USB connection.

1. To start, open PCWIN.

www. kepware.com