Toyopuc PC3/PC2 Ethernet Driver
A routing command can only be issued through a maximum of four devices. Routing allows the Ethernet
driver to request data from non-Ethernet devices. To request data from Device 3, the driver can route a
command through Device 1 onto Device 2 then to Device 3.
Examples
1. Defining a Device ID to request data from Device 1. Device ID: 205.167.7.101.
2. Defining a Device ID to request data from Device 3. Device ID: 205.167.7.101[L1,S1,L2,S2].
Note: Lx and Sx represent the Link/Station numbers assigned to a device. . Consult the Toyopuc PC2 EN-I/F
manual, HPC Link manual, or FL/ET-T-V2H manual for more information on link/station numbers.The L and S
must be included as part of the Relay routing information when specifying a Device ID. The Px represents the
program number for PC3J systems. The Px value should precede the link variable on each layer of the route.
Example
Device ID: 205.167.7.101[P2,L1,S1,P1,L2,S2].
Channel Properties - General
This server supports the use of simultaneous multiple communications drivers. Each protocol or driver used
in a server project is called a channel. A server project may consist of many channels with the same
communications driver or with unique communications drivers. A channel acts as the basic building block of
an OPC link. This group is used to specify general channel properties, such as the identification attributes
and operating mode.
www. kepware.com
6
To Next Page
Loading...