Toyopuc PC3 - Configuring the FL;ET-T-V2 Ethernet Module

To Next Page

To Previous Page

Toyopuc PC3/PC2 Ethernet Driver

Configuring the FL/ET-T-V2 Ethernet Module

Before the FL/ET-T-V2 card can be used for communications, it needs to be configured to use PCWIN. At this

point, users should know how to configure PCWIN to connect to the PLC. For more information, refer to the

Toyopuc FL/ET-T-V2 Ethernet Module Users Manual.

1. To start, open PCWIN.

2. Read the existing program and parameters from the PLC by clicking on CPU | Read Data. Select the

proper option.

www. kepware.com