Toyota 62-8FDU30 User Manual

8-1738 TROUBLESHOOTING
Control type
Phenomenon on
vehicle
Malfunction area
and mode
Checking method Corrective action
Mini lever function
Mini lever, joystick
lever vehicles:
Backward tilt auto-
matic fork leveling
does not stop. (Con-
tinues to tilt to back-
ward most tilt posi-
tion without stopping
at the level position)
▪ Tilt angle sensor
unit:
Sensor defect
▪ Tilt angle sensor
installation:
Link, installation
part destroyed,
damaged
Tilt angle sensor
voltage check:
Tilt to forward and
backward tilt posi-
tions and check the
voltage change.
If there is no
change, perform an
installation check or
replace the sensor.
▪ Horizontal
matching value
for tilt angle
sensor:
Does not match
actual status (re-
match)
-
Follow matching pro-
cedure to rematch.
▪ Automatic fork
leveling switch
unit:
Open fault (in-
ternal damage)
▪ Automatic fork
leveling switch
detection mech-
anism (mini
lever, joystick
lever)
Detection part
gap adjustment
defect
▪ Automatic fork
leveling switch
line (Power sup-
ply, signal,
ground):
Disconnection
fault (Harness,
connector)
ON/OFF check with
analyzer
Harness check or re-
place switch
▪ Display setting:
Backward tilt
automatic fork
leveling is deac-
tivated
Check the option set
content
Change
▪ SAS/OPS con-
troller:
Controller defect
- Replace
Mini lever, joystick
lever vehicles
Backward tilt auto-
matic fork leveling
does not stop.
(Stops at a position
slightly off the level
position)
Refer to forward tilt
automatic fork level-
ing does not stop
(stops at the position
where the automatic
leveling switch is
pressed).
- -
8

Toyota 62-8FDU30 Specifications

General

Brand	Toyota
Model	62-8FDU30
Category	Forklifts
Language	English