Toyota 8FGU15 Repair Manual

8-190 8 TROUBLESHOOTING
Error Code: 61-3
Failure mode: Pressure sensor open abnormality (P-port)
Probable cause
▪ Connector contact defect
▪ Pressure sensor defect
▪ Harness defect
▪ SAS/OPS ECU defect
Related portion
5 (E2)
SAS/OPS
ECU
Pressure sensor
A21
20 (5PBR)
31 (PBRK)
1 (B)
A103
2 (P)
3 (E)
(P-port)
STEP1
1. Disconnect the battery negative terminal, after inspecting
and correcting disconnection and water entry of A103 and
A21.
2. Reconnect all connectors and the battery negative terminal.
3. Turn the ignition key switch ON (engine stopped) and check
whether or not there is an error.
Judgment
Result Procedure
Error
Go to STEP2 [page 191].
No error Connector contact defect

Toyota 8FGU15 Specifications

General

Model	8FGU15
Category	Forklifts
Engine Type	Internal Combustion
Load Capacity	3000 lbs
Lift Height	189 inches
Tire Type	Pneumatic
Engine	Toyota 4Y
Power Source	Gasoline