7-637 DISPLAY
7.1.6 ADMINISTRATOR FUNCTIONS
The multi-function display DX provide administrators to adjust performance and set up some functions.
These functions are password-protected not to be changed by general operators.
Entering the password displays the setting menu for administrator.
7.1.6.1 Administrator functions list
Group Setting Screen
Travel Functions
Speed Setting of Low Speed *
Speed Setting of Speed Limiter
Speed Setting of Over Speed Alarm *
Vehicle Management Functions
Setting of Maintenance Hour Meter
Setting of Engine Auto Stop
Setting of Administrator's Second Password
Switching of Menu Lock
*: When menu lock setting is released, the operator can set it.
7.1.6.2 Administrator password
Password Entry Procedure
NOTICE
If an operation error occurs during entry operation, turn the key switch OFF and start over again.
Step Display Operation Vehicle response
1
Press switch (2) and switch (4)
at the same time for more than
2 seconds.
When pressing the
switches, a short beep
sounds, and after 2
seconds another short
beep sounds.
2
Press switch (3) within 10
seconds.
A short beep sounds.
3
Press switch (3) within 10
seconds.
A short beep sounds.
4
Within 10 seconds, press
switch (2) and switch (4) at the
same time for more than 2
seconds.
When pressing the
switches, a short beep
sounds, and after 2
seconds repeated short
beeps sound.
7
To Next Page
General
