36
Sewing
When using the buttonhole cutter to cut the buttonholes, do not hold the fabric in
front of the cutter.
Doing so could cause an injury to your hand.
Use the buttonhole cutter to cut the center, making
sure not to cut the stitches.
Note : If a marking pin is put in the bar-tack area
it helps to prevent excessive cutting with
the buttonhole cutter.
Adjustment of buttonhole balance
Use the buttonhole adjustment screw to adjust
the balance between the stitches. (rear side)
Adjust by turning with the needle plate screw
driver.
If the stitches are loose on the right side of the
buttonhole, turn slightly in the "-" direction.
If the stitches are loose on the left side of the
buttonhole, turn slightly in the "+" direction.
To Next Page
Loading...
