10 VSS3
2.5. Arm without additional sensors
For example, if you have an inclination sensor, you need to deactivate it when you are travelling by
boat or train, or if you are parking in a car park served by lifts.
If your alarm system has additional sensors, you can deactivate them as follows:
Activation steps Hazard light
indication
Alarm status
light (LED)
Buzzer
1 Lock the car by the
remote control.
Flashes once. On for 30 sec. 1 beep sound if
buzzer enabled.
2 During the rst
30 sec., press the
lock button again
twice.
Flashes once. On for 30 sec. 1 beep sound if
buzzer enabled.
Summary:
press the remote
3 times within
30 sec.
Note:
– The sensor is deactivated for 1 use only. Next time you arm the alarm, the sensor will be
activated again.
2.6. Automatic re-arming
If the car is unlocked using the remote control, and the boot or doors are not opened within
30 seconds, the security system will automatically re-arm when the car automatically relocks.
To Next Page
Loading...
