VSS3 11
2.7. Alarm status light (LED)
The status LED is used to give information to the user, during normal operation, and as a
diagnostic tool.
Condition Alarm status light (LED)
Disarm state: LED off
Pre-arm state (30 sec
arming time):
LED on
Arm state: LED blinking
Alarm state: LED blinking
Programming mode
selection:
LED on when entering the mode, after blinking
After an alarm: Number of ashes gives feedback from alarm cause
2.8. Back-up battery
Your alarm system has a rechargeable battery back-up. It is fully recharged after 12hrs of driving.
To Next Page
Loading...
