Toyota vss3 - Alarm System Glossary

18 VSS3
Problem Possible causes Possible solutions
LED
Always ON You are in programming mode. Close bonnet to exit program
mode.
Always OFF System problem. See No arming.
30 seconds ON System is still in pre-arm phase. Wait 30 sec. to enter arm state.
Blinking fast at IG
ON
Garage mode is activated. See garage mode.
Blinking slow Alarm system is activated.
No arming
Fuse is broken. Check dome lamp fuse.
Central unit is broken or
disconnected.
Contact your authorized retailer.
Wire harness is damaged. Contact your authorized retailer.
6. Glossary
ARMING: Operational state in which the product is protecting the vehicle.
DISARMING: Product in the operational state that allows the vehicle to be started without setting
off the alarm.
PRE-ARM: Functional state preceding the arm mode, in which the product does not give any
alert.
TAMPER: Removal, cutting or disconnection of the power or communication wires.
BUZZER: The internal loudspeaker of the alarm system used as a beeper.
PIN CODE: Personal Identication Number, used to deactivate the alarm sytem.