Toyota vss3 - Alarm System Arming and Disarming; How to Arm the Alarm

VSS3 7
2. Arm / Disarm
The alarm system will be armed when you lock the car, and disarmed when you unlock the car
using the remote key.
2.1. To ARM the alarm system
Important:
To prevent false alarm, check that there is no one in the car, and that all windows and sliding
roofs are closed before locking the car (see how to deactivate the interior intrusion sensor in
paragraph 2.4).
Action Hazard light indication Alarm status light (LED)
Remote control: Press the
lock button once.
Flashes once. ON for 30 seconds, then
starts ashing.
Note:
– The car LED blinks to inform you that the immobiliser is set (not linked to alarm system)
– If any door is not securely closed, 10 short beeps will sound (car will not be locked, but alarm
system will be armed) and the switch will be deactivated until door is closed properly.
– The system will be armed 30 seconds after the lock button is pressed (pre-arm time).
– If your remote key is not working, you can arm the system by PIN code (see chapter 3.2).
LOCK
(Arm)
UNLOCK
(Disarm)