19
Chapter 4
¾ Repeater/Bridge Mode
If Repeater/Bridge mode is selected, please take the following steps:
1 ) Select the wireless network 2.4GHz or 5GHz to connect. Here we take 2.4GHz
for demostration.
2 ) Enter the exact same wireless settings of the Host network that you want to
connect to. Or click Wireless Scanner and choose a Host network from the list.
Once a network is selected, its SSID, MAC address and security settings (except
the password) will be automatically filled in the respective fields. If the selected
network is protected, enter the password.
3 ) Click Save to save the settings.
4 ) Select the wireless network 2.4GHz or 5GHz to configure the extended wireless
settings. Here we take 2.4GHz for demostration.
5 ) The wireless radio is enabled by default. Customize the Wireless Network Name
(SSID) and Security settings. The AP device provides four security options, None,
WPA/WPA2 - Personal, WPA/WPA2 - Enterprise and WEP. The default WPA/WPA2
- Personal is recommended. Enter a Password below to prevent unauthorized
access to your AP device.
To Next Page
Loading...
