EasyManua.ls Logo

TP-Link Archer VR200v - Connecting the Telephone; DECT

TP-Link Archer VR200v
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Chapter 5
Telephony
5. 1. Connecting the Telephone
Connect your telephone to the RJ11 ports on the back panel.
FON 1 FON 2 DSL USB1 USB2LAN1 LAN2 LAN3 LAN4/WAN PowerPower
On/Off
5. 2. DECT
The modem router is integrated with DECT (Digital Enhanced Cordless
Telecommunications) function. With this function enabled, you can register your
cordless phone on the modem router and make calls via internet.
5. 2. 1. Registering Cordless Phone
There are two ways to register your DECT cordless phone.
Method 1: Via DECT Button
1. Set your DECT cordless phone in the registration mode, and then press and hold
the DECT button on the DSL router for about 3 seconds until the Phone LED
flashes.
DECT
DECT
2. Enter the PIN (Default: 0000) on the DECT cordless phone if required.
Notes:
1. Up to six DECT cordless phones can be registered on the modem router.
2. If you press the DECT button for more than 4 seconds, and the Phone LED still does not light, release the button
and try again.
Method 2: Via Web Management Interface
Follow the steps below to register:
1. Visit http://tplinkmodem.net, and log in with the password you set for the router.
2. Go to Advanced > VoIP > Telephony Devices to open the registration page.

Table of Contents

Related product manuals